1.The cleaning work of the tile press equipment is very important. Whether it is the surface of the tile press equipment, or the wheels, driving input shaft, pinion gears, large gear parts and driving upper shaft, we should pay attention to regularly Dust and greasy dirt and other dirty things are dropped, you should also check whether the lubrication of various gears and bearings is normal, and regularly apply lubricant on them.

2. When the tile press equipment is in normal work, it should be forbidden to perform daily work in a state where it exceeds a small closed height. The specific performance is that the distance between the bottom surface of the upper sliding box and each working surface at work is kept at a minimum of 290mm; the height of the upper and lower abrasive tools and the thick bottom of the upper and lower pads, plus the thickness of the tile blank, it is also good not to exceed the total height of 290mm range. Otherwise, once a machine tool accident occurs, you will regret it.

3. After that, let’s take a look at the indexing situation of the workbench. It is composed of a gear set mounted on the upper shaft end, a transmission pin gear, and a groove wheel on the hexagonal runner shaft to achieve the indexing positioning of the tile press. Working; at both ends of the upper shaft of the tile pressing machine, there is a return cam conjugated with the pressing cam mounted on the same tile pressing machine shaft, so that the operator can achieve it through the positioning rod or the positioning disk The lower die is positioned at the working position; there are also lubricating pumps installed in the case on both sides of the role of the tile press, and a device for sending lubricating oil to the various frictional movement parts. We only need to keep in mind the above, and only then can we add it during the work of the tile press.