With the rapid development of China nowadays, the cold bending forming technology has developed rapidly. In the cold bending industry, power supply is a very important place to pay attention to.

First of all, you must choose a flat table, and stabilize the machine. You can pull the chassis feet apart to make the machine panel easy to observe. Insert the plug on the handheld sensor head into the socket on the panel and tighten it, paying attention to the positioning gap.

Secondly, insert one end of the power cord plug into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use a single-phase three-wire power supply. Then turn on the “POWER SW.” on the rear panel of the chassis, press the “SWITCHING” button on the panel, and wait for the “WARM UP” green indicator to light, and the machine can work. Hold down the “SETTING BUTTON” button and set it to an appropriate value, generally between 0.5-2.0 seconds.

Put the sensor head on the container lid again and press the start button on the handle. At this time, the “HEATING” red indicator light is on, indicating that the heating is in progress. Do not remove the sensor head, and the “HEATING” red indicator light is off Then remove the sensor head.

Wait until the green light of “WARM UP” lights up or the short beep of “buzzer” inside the machine can start the next container sealing operation. Check the sealing quality, according to different materials, diameter containers and production efficiency, properly modify the “SETTING BUTTON” button, making the sealing quality super good.

Always pay more attention to details when using electricity. If you want to know more industry knowledge, please consult Liming stamping form machine Co., Ltd.