Notes for use:

1. Start the plate cutting machine and make some idle cycles to ensure that under normal circumstances, the sheet materials with different thickness can be cut from thin to thick.

To ensure that the user is familiar with the cutting machine performance.

2. The clearance of different blade must be adjusted for different plate thickness during the test cutting.

If the corresponding blade clearance is not adjusted, the durability of the blade will be affected.

3. The pressure gauge switch is opened in the shearing process of the plate shears to observe the oil pressure value. The pressure of the 12mm board shears should be less than 20MPa.

This remote pressure-regulating valve No9, the pressure is set at 20-22mpa at the time of delivery, the user must comply with this regulation, and shall not increase the pressure for the material surface of the over-specified shear, causing damage to the machine.

4. Sound balance during operation.

If there is any noise in the board shears, stop and check.

5. During the operation of the plate shears, when the fuel tank temperature is raised less than 60 degrees, it will shut down and rest.