1, the inversion of tile press workbench is installed on the shaft end gear set, dial pin gear transmission, toggle mounted on the six-party turn sheave on the shaft to implement dividing positioning, on the shaft at each end is equipped with a and installed on the same shaft and suppression of conjugate CAM to CAM, lower die are implemented by locating rod and the positioning plate orientation in the work place.Lubricating pumps are installed on both sides of the chassis. When the machine is working, the tubing transmits lubricating oil to each frictional moving part.Those who understand the structure and performance of the machine and its operating procedures shall not operate the machine.
2, it is strictly more than a small closed height to work, that is, to slide the bottom of the box to work in a small distance of 290 mm above the mold after the height plus up and down the plate thickness plus tile billet thickness, not allowing more than 290 mm above the manufacturing mold should be designed according to the requirements, in order to avoid machine tool accidents.
3. Always pay attention to the height of lubricating oil in the sliding box and both sides of the body.Equipment should often wipe, keep clean, no mud and water.
4, to press around the tile machine and roller surface are clean.The molding process of this equipment: the motor drives the input shaft through the belt wheel, and drives the upper shaft through the pinion and big gear.A set of CAM mechanism drives the sliding pedestal with upper die to move up and down to realize tile pressing.