The processing procedure of the rolling door equipment is summarized: try to choose materials with high abrasion resistance, and heat-treat the surfaces that are often subject to friction, so that the wear resistance and hardness of the equipment parts will also be improved. In addition, the performance of the material will also be affected by environmental factors, such as high temperature, high pressure, etc., so in this case, choose materials such as powder metallurgy materials and graphite to make parts, the effect will be better. The above requirements are all proposed to be able to wear the parts of the roller shutter door equipment, so as to enhance the use value of the machine equipment.

The roller shutter door equipment is used to carry out various processes in the production process of the roller shutter door. After a long and continuous operation process, each part of the equipment will have different degrees of wear and tear. If it is not replaced in time, it will affect the processing of the roller shutter door. A good solution is not to solve the problem after it has occurred, but to prevent it. Therefore, the selection of parts and materials in rolling door equipment is very critical. The roller shutter door is a series of multi-joint movable door pieces connected together in a fixed slideway, and the door above the door is rotated by the scroll shaft above the door. The roller shutter door acts as a horizontal partition like a wall. It consists of a curtain board, a seat board, a guide rail, a support, a reel, a box, a control box, a door roller, a limiter, a door lintel, a manual quick release switch device, and a button switch. It is composed of 13 roller shutter door accessories, such as a safety device, and is generally installed in a place where it is inconvenient to use wall separation.