Recently, many customers have suggested that cheap is not good, but good is not cheap, so how to judge the quality of the color steel tile press machine? The key to the color steel tile press equipment is that its shaft uses a solid shaft, and the accuracy of the goods produced by the solid shaft is relatively good. Before using the molding tile press equipment, it is necessary to check whether each connection is firm, whether the installation bolts and nuts are tightened, and the left and right chassis should be filled with lubricating oil to start the power supply for test run. First, run the empty car carefully and observe whether there is vibration , Noise, whether oil comes from the oil window, whether the movement of each part is coordinated, and the mold can only be installed after the mold is installed. When installing the mold, cut off the power, manually move the motor belt or large gear, index the worktable, and raise the slide to High point, it is easy to use an object to support between the worktable and the bottom surface of the slide seat, and the natural fall with the non-slip seat causes an accident.

The mold used by the tile press machine requires an upper mold and six lower molds of the same size. First install the upper mold and one lower mold. The lower mold is directly installed on the hexagonal runner table, and the upper mold is installed on the bottom surface of the slide And place the appropriate thickness of the backing plate. After the upper and lower molds are closed, the gap between the four sides is uniform, and the distance between the upper and lower molds is equal to the thickness of the required tile blank. Then, the upper mold shall prevail, the worktable shall be indexed, and the remaining lower molds shall be installed.