The processing procedure of the printing roller shutter door equipment is summarized: the printing roller shutter door equipment should be made of materials with high wear resistance as much as possible, and heat treatment should be performed for the surface that is often subjected to friction, so that the wear resistance and hardness of the equipment parts will also be improved. In addition, the performance of the material will also be affected by environmental factors, such as high temperature, high pressure, etc., so in this case, choose materials such as powder metallurgy materials and graphite to make parts, the effect will be better. The above requirements are put forward to prevent the wear of rolling door equipment parts, so as to enhance the use value of printing rolling door equipment.

The printing roller shutter door equipment is used to carry out various processes in the production process of the roller shutter door. After a long-term continuous operation process, each part of the equipment will have different degrees of wear and tear. If it is not replaced in time, it will affect the processing of the roller shutter door. The good way is not to solve the problem after it occurs, but to prevent this problem, so the selection of parts and materials in the printing roller shutter door equipment is very critical. The printing roller shutter door is a series of multi-joint movable door pieces connected together in a fixed slideway, and the door above the door is rotated by the scroll shaft above the door. The roller shutter door acts as a horizontal partition like a wall. It consists of a curtain board, a seat board, a guide rail, a support, a reel, a box, a control box, a door roller, a limiter, a door lintel, a manual quick release switch device, and a button switch. It is composed of 13 roller shutter door accessories, such as a safety device, and is generally installed in a place where it is inconvenient to use wall separation.